0
×

Your shopping cart is empty.

View Cart
  • Home
  • Art Stamps
  • Bulk Rate Rubber Stamp
  • Champ Stock Message Stamps
  • Check Endorsement Stamps
  • Clothing Stamps
  • Consultant Rubber Stamp
  • Corporate Seals and Rubber Stamps
  • Custom Logo Rubber Stamps
  • Custom Rubber Stamps
  • Custom Desk Nameplates
  • Custom Embossers
  • Daters & Numberers
  • Engraved Items
  • Engineering and Architect Stamps
  • Gift Certificates
  • Eco Green Products
  • Hand Wood Stamps
  • Hand Stamps for Events
  • Holiday Rubber Stamps
  • Inks & Pads
  • Inspection Rubber Stamps
  • Invisible Ink
  • Large Rubber Stamps
  • Letter & Number Stamps
  • Library Stamps and Seals
  • Custom License Plate Frames
  • Marker Pens
  • Monogram Stamps and Seals
  • Name Badge
  • Notary Stamps by State
  • Notary Supplies
  • Patriotic and Religious Rubber Stamps
  • Permanent Marking
  • Permanent Quick Dry Rubber Stamps
  • Pink Breast Cancer Awareness Stamps
  • Personalized Pocket Stamps
  • Professional Stamps
  • Redacting Products
  • Replacement Pads
  • Round and Oval Rubber Stamps
  • Rubber Stamps
  • Rubber Stamps for Frequent Buyer Cards
  • Signature Rubber Stamp
  • Stamping Pens
  • Stamp Pads - Inks - Accessories
  • Stock & Specialty Stamps
  • Stock Message Rubber Stamps
  • UV Ink Stamps - Skin
  • Wedding Stamps
  • Where's George Rubber Stamps
  • Extra Large Ink Stamps
  • Extra Large Hand Stamps
  • Fax Order Form
  • Fonts & Sizes
  • DISCOUNT RUBBER STAMPS and SPECIALS
  • Knockout Specials
  • Office Supplies
Re-Inking Comet Self-Inking Stamps

Step 1: Lock Stamp
Lock stamp
Press the stamp down completely and insert the swing lock into the stamp frame. This should completely lock the stamp in place.
Step 2: Push Pad Out
Push pad out
With the stamp still in the locked position, press outward on the metal lip protruding from the back of the stamp pad to push the pad out of the housing.
Step 3: Remove Pad
Remove pad
Slide the pad completely out of the machine.
Step 4: Apply Ink
Apply ink
Place the pad over a piece of scrap paper with the felt side facing up. Place approximately 25 drops of ink across the center of the pad.
Step 5: Spread Ink
Spread ink
Use the tip of the ink bottle to spread out the ink over the center of the pad’s felt material and allow a few minutes for the ink to settle in.
Step 6: Reinsert Pad
Reinsert pad
Carefully re-install the pad (avoid touching the wet spots on the felt side) into the housing and make sure the pad is snapped firmly back into place.
Step 7: Release Lock
Release lock
Remove the swing lock from the frame to allow the stamp’s assembly to rotate completely back to the pad.
All Done!
All done!
Your stamp is now inked and ready for use.